4. Using an Atlas Controller to select Mainline or Program track.
Connect the Commander to an Atlas Controller as shown in Figure 2.
• Connect the Controllers X & Y screws to the siding or section of
track to be used for programming.
T
o Use Siding For Mainline:
• Set the A & B reversing switches in the center position.
• Set the A / B switch to the A position.
• Set the X/Y reversing switch so the train can enter the siding/
programming track without shutting down the Commander.
T
o Use Siding For Programming:
• Set the A / B switch to the B position for programming.
5. Plug the Power Cord of the Generator into a 120VAC power
outlet (US standard).
Please note that terminals C & D may be used to add additional Power
Stations. Please see page 27 for an explanation of Power Station usage.
XpressNET is a high-speed digital network based upon the industry standard
RS-485 protocol. The Atlas Commander uses XpressNET to communicate
between its high-speed components such as the HandCommand. XpressNET
communicates at 62.5 thousand bits per second (nearly 4 times faster than its
closest competitor). It is the highest performance network in widespread DCC
use and all its protocols are freely available to both the industry and the hob-
byist. XpressNET is an industrial based technology, which can be setup in an
infinite number of possibilities, making it simple to setup and control any lay-
out, large or small.
NOW YOU'RE READY TO RUN YOUR
TRAINS WITH DCC!
USING THE ATLAS MASTER DCC COMMANDER
Buttons And Their Function
Dial - Used to control the speed of the selected locomotive.
and - Used to select the direction of the selected locomotive. Press both
buttons simultaneously to access the Menu system.
Stop - Press this button to turn the track voltage on or off. Also press this but-
ton to turn the track voltage on after removing a short from the track.
F0, F1, F2* - Use to control locomotive and accessory decoder functions.
These buttons are also used for Menu operations. When in the menu, F0 func-
tions as the Enter button and F2 functions as the Exit button.
Press and hold the Forward or Reverse button and press F1 to control
function 3 (F3) or F2 to control function 4 (F4).
5
6
(261 pagine)
(92 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale