* The number of accessible functions depends on the capabilities of the
decoder installed in your locomotive.
“+” and “-” - Used to select the address of the locomotive you wish to
control. When in the Menu use to select Menu options or to set parameters.
Understanding Locomotive Decoder Addressing
Each decoder-equipped locomotive has an address. The address is how the
Commander identifies which locomotive it is controlling at any given time.
Using the Commander you can easily control the speed, lights, and other func-
tions (if available) of up to 99 engines!
To program a locomotive's address, go to page 15.
RUNNING YOUR LOCOMOTIVE
When you turn the Commander "on", the display will default to the Locomotive
display, Lxx (xx is a locomotive address). Select the locomotive you desire to
control using the “+” and “-” buttons. Once you've reached the desired
address, you may acquire the locomotive by adjusting the speed, changing the
direction of the locomotive, or activating a function.
Controlling the Speed of Your Locomotive
The speed of the selected locomotive is controlled with the dial. Turning the
dial clockwise increases speed, turning it counter clockwise decreases the
speed. In full counter clockwise (ccw) position the locomotive stops and the full
clockwise position sets maximum speed.
Changing Directions
The and buttons are used to control the direction of the selected loco-
motive:
Key
Display
Forward - A dot will appear to the
upper left of the centermost LED.
Reverse - A dot will appear to the
lower left of the centermost LED.
The direction of travel changes only after the key is released. The display will
show the selected direction.
If you change the direction while the locomotive is still moving (speed dial not
fully ccw), the locomotive will decrease speed (brake) with the preset decel-
eration setting until it comes to a full stop and then accelerate in the opposite
direction with the preset acceleration setting. For more information on accel-
eration and deceleration settings (and programming same), see page 16.
Activating Functions*
Buttons F0, F1 and F2 are used to control functions on the selected locomo-
tive, and to control turnouts or other accessories via an accessory decoder. For
information on controlling your turnouts, please see page 13.
Function zero - F0 - controls the front and rear light headlight (these lights
are directional by default and may be configured for independent control).
The user may configure function 1 -F1, function 2 - F2, function 3 - F3, and
7
8
.
.
(261 pagine)
(92 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale